Stillare - RDA V3 - Copper


The Stillare V3 is a solid RDA. Keeping with the vertical coil concept presented in the 454 Big Block RDA, coils are wrapped around the ground screws along the outside edge. Each screw is surrounded by a small "trench" that guides your wire to the appropriate place. Then, the positive leads of your 3 coils are inserted through the closest hole on the positive post. There are 6 slots in the positive post, allowing each coil lead it's own path all the way through the post. The Stillare V3 features a 3mm juice well in a stainless steel deck for maximum e-liquid retention without leaks.

The top cap has adjustable airflow like its predecessor, which is adjusted by turning the very top of the two-piece cap. There are three airflow slots which, when opened all the way, give excellent airflow which the average person could breathe through. However, because the draw is adjustable, you can keep it as open or as tight as you prefer. The diameter of the RDA is 22mm with an adjustable positive pin, so it will sit flush on most mechanical mods.


  • 1 x  Stillare V3 RDA
  • 1 x Drip Tip
  • 2 x Replacement O-rings
  • 2 x Replacement screws
  • 6 inches of 28-gauge Kanthal
  • 1 x Strand of Braided Silica Wick
  • 1 x little blue screw driver


NOTE:  These units carry no warranty and are used at the customer's own risk.  All equipment warranties are null and void if used with these products.

SVL does not recommend or condone the use of sub ohm coils and will not be responsible for personal injury or damage to property.

$14.95 $29.95

Share this product